Estimasi Sumberdaya Andesit Dengan Metode Geolistrik Resistivity 2d Di Kabupaten Kulonprogo D.I.Y

Authors

  • Kelvin Zain Universitas Pembangunan Nasional "Veteran" Yogyakarta
  • Nurkhamim Nurkhamim Universitas Pembangunan Nasional "Veteran" Yogyakarta
  • Aldio Kresna Pambayu Universitas Pembangunan Nasional "Veteran" Yogyakarta
  • Faizal Agung Riyadi Universitas Pembangunan Nasional "Veteran" Yogyakarta
  • Oktarian Wisnu Lusantono Universitas Pembangunan Nasional "Veteran" Yogyakarta

DOI:

https://doi.org/10.30872/jtm.v14i1.25218

Abstract

Andesite is a vital industrial mineral commodity widely utilized as construction material, necessitating accurate information regarding its geometry and resource potential. To address the data requirements for construction material exploration, a geophysical investigation was conducted to estimate andesite resources using the 2-dimensional (2D) geoelectrical resistivity method in Dukuh Gunung Kukusan, Hargorejo Village, Kokap District, Kulon Progo Regency, Special Region of Yogyakarta. Field data acquisition was carried out on four survey lines utilizing the Wenner-Schlumberger configuration. The data processing stage involved 2D inversion using RES2DINV software, followed by 3-dimensional block modeling via Geosoft Oasis Montaj for volume calculation. Interpretation results indicate that fresh andesite is characterized by relatively high resistivity values, ranging from 1000–1870 Ωm, whereas weathered andesite is characterized by lower resistivity values, ranging from 300–800 Ωm. Fresh andesite is identified starting at an average depth of ± 15 meters below the surface, exhibiting a distribution pattern extending from Southwest to Northeast, which aligns with the regional geological structure. Based on 3-dimensional modeling, the estimated volume of fresh andesite resources is 95,875 m3 and the volume of weathered andesite is 160,125 m3. The results of this study are expected to provide valuable preliminary information for planning the utilization of andesite resources and serve as a reference for the application of the 2D electrical resistivity method in the exploration of construction rocks.

Author Biographies

  • Kelvin Zain, Universitas Pembangunan Nasional "Veteran" Yogyakarta

    Undergraduate student of Mining Engineering, Faculty of Mineral Technology and Energy, Universitas Pembangunan Nasional “Veteran” Yogyakarta, Indonesia.

  • Nurkhamim Nurkhamim, Universitas Pembangunan Nasional "Veteran" Yogyakarta
    Undergraduate student of Mining Engineering, Faculty of Mineral Technology and Energy, Universitas Pembangunan Nasional “Veteran” Yogyakarta, Indonesia.

References

Amir, H., Akmam, Bavitra, & Azhari, M. (2017). Penentuan Kedalaman Batuan Dasar Menggunakan Metode Geolistrik Tahanan Jenis dengan Membandingkan Konfigurasi Dipole-Dipole dan Wenner di Bukit Apit Puhun Kecamatan Guguk Panjang Kota Bukittinggi. Eksata, 18(1).

Bemmelen, V. (1949). The Geology of Indonesia Volume IA: General Geology of Indonesia and Adjacent Archipelagoes.: Vol. IA. Government PrintingOffice.https://www.researchgate.net/publication/293743528_Van_Bemmelen_IA

Budhu, M. (2015). Soil Mechanics Fundamentals (Imperial Version). Wiley Blackwell. https://www.academia.edu/82691170/Soil_mechanics_fundamentals_by_muni_budhu

Darling, P. (2011). SME MINING ENGINEERING HANDBOOK (third). Society for Mining, Metallurgy, and Exploration, Inc. https://docshare02.docshare.tips/files/11779/117797841.pdf

Fariza, M., & Pujiastuti, D. (2024). Penentuan Potensi Cadangan Batu Andesit Menggunakan Metode Geolistrik Tahanan Jenis di Koto Alam, Kabupaten Lima Puluh Kota. Jurnal Fisika Unand, 13(3), 420–426. https://doi.org/10.25077/jfu.13.3.420-426.2024

Giamboro, W. S., & Hidayat, W. (2016). PEMODELAN 3D RESISTIVITAS BATUAN ANDESIT DAERAH SANGON, KAB. KULONPROGO, PROVINSI DIY. JIK TekMin, 28.

Grandis, H. (2009). Pengantar Pemodelan Inversi Geofisika. Himpunan Ahli Geofisika Indonesia (HAGI).

Herman, R. (2001). An introduction to electrical resistivity in geophysics. American Journal of Physics, 69(9), 943–952. https://doi.org/10.1119/1.1378013

Husein, S., & Srijono. (2016). Peta Geomorfologi Daerah Istimewa Yogyakarta. https://www.researchgate.net/publication/308415694

Jayadi, H., Meidji, I. U., & Tang, B. Y. (2020). Identifying Andesite Rocks Sources Using Geoelectrical Resistivity in Loli, Donggala Regency, Central Sulawesi. JPSE (Journal of Physical Science and Engineering), 4(2), 45–54.https://doi.org/10.17977/um024v4i22019p045

Loke, M. H. (2004). Tutorial : 2-D and 3-D electrical imaging surveys. www.geotomosoft.com

Martínez, J., Rey, J., Sandoval, S., Hidalgo, M. C., & Mendoza, R. (2019). Geophysical prospecting using ERT and IP techniques to locate Galena veins. Remote Sensing, 11(24). https://doi.org/10.3390/rs11242923

Matsui, T., Park, S. G., Park, M. K., & Matsuura, S. (2016). RELATIONSHIP BETWEEN ELECTRICAL RESISTIVITY AND PHYSICAL PROPERTIES OF ROCKS. First Conference on Geophysics for Mineral Exploration and Mining, 2016. https://doi.org/https://doi.org/10.3997/2214-4609.201602101

Prastowo, R., Helmi, H., Trianda, O., & Umam, R. (2021). Identification of Andesite Resource Potential In Kalirejo Area, Kokap Sub-District, Kulon Progo Using Resistivity Method. Forum Geografi,35(1).https://doi.org/10.23917/forgeo.v35i1.13507

Prastowo, R., Pambudi, S., Rizqi, A. H. F., Ipmawan, V. L., Arimurti, D. A., & Radhitya, B. D. (2024). 3D Modeling of of Distribution Andesite and Breccia Rocks Using Geoelectric Resistivity in Potential Areas of Minerals in Madiun Regency, Indonesia. International Journal of Hydrological and Environmental for Sustainability, 3(2), 89–101. https://doi.org/10.58524/ijhes.v3i2.474

Pringgoprawiro, H. (1981). Stratigrafi Daerah Kulon Progo, Yogyakarta. Buletin Geologi, 13(2), 1–15.

Purnomo, H., Prastowo, R., Hibullah, M. H., & Pambudi, S. (2023). Estimasi sumberdaya andesit menggunakan metode ordinary kriging berdasarkan pengukuran geolistrik di PT. Zlaw Group Boyolali, Jawa Tengah. Jurnal Teknologi Mineral Dan Batubara, 19(1), 1–13. https://doi.org/10.30556/jtmb.Vol19.No1.2023.1336

Reynolds, J. M. (1997). An Introduction to Apllied and Environtmental Geophysics. Jhon Wiley & Sons, Ltd. https://www.academia.edu/35804474/An_Introduction_to_Appliedand_Environmental_Geophysics

Sawayama, K., Kitamura, K., & Fujimitsu, Y. (2018). Relationship between Complex Resistivity, Elastic Wave and Water Saturation of Cracked Andesite under Laboratory Fluid-Flow Test . Butsuri-Tansa (Geophysical Exploration), 71. https://doi.org/https://doi.org/10.3124/segj.71.71

Sertçelik, I., Kurtuluş, C., Sertçelik, F., Pekşen, E., & Aşçi, M. (2018). Investigation into relations between physical and electrical properties of rocks and concretes. Journal of Geophysics and Engineering, 15(1), 142–152. https://doi.org/https://doi.org/10.1088/1742-2140/aa87ca

Sihombing, J., & Lepong, P. (2023). Eksplorasi Batuan Andesit Berdasarkan Interpretasi Data Resistivitas Di Desa Petangis, Kecamatan Batu Engau, Kabupaten Paser. Jurnal Geosains Kutai Basin, 6.

SNI 4726. (2019). " Standar Nasional Indonesia Pedoman pelaporan hasil eksplorasi, sumber daya, dan cadangan mineral. www.bsn.go.id

Sosrodarsono, S., & Takeda, K. (2003). Hidrologi Untuk Pengairan. PT Pradnya Paramita. https://kupdf.net/download/hidrologi-untuk-pengairan_58f5d630dc0d601c0cda97e8_pdf

Telford, W. M. ; G. L. P. ; S. R. E. (1990). Applied Geophysics (2nd ed.). Cambridge University Press.https://www.scribd.com/document/370399433/Applied-Geophysics-Second-Edition-pdf

Wahyono, S. C., Atmadja, K. G., & Siregar, S. S. (2020). IDENTIFICATION OF ANDESITE ROCK BASED ON THE RESISTIVITY VALUE IN SATUI AREA, SOUTH KALIMANTAN. JGE (Jurnal Geofisika Eksplorasi), 6(3), 173–182. https://doi.org/10.23960/jge.v6i3.93

Winda, & Pulungan, A. (2024). Estimasi Sumberdaya Batugamping Menggunakan Metode Geolistrik Resistivity 2D Konfigurasi Pole-Pole di Kabupaten Aceh Selatan. https://doi.org/10.58860/jti.v3i1

Downloads

Additional Files

Published

2026-06-30

Issue

Vol. 14 No. 1 (2026): Jurnal Teknologi Mineral FT UNMUL Juni 2026

Section

Articles

License

Copyright Notice

Authors who publish in JURNAL TEKNOLOGI MINERAL FT UNMUL agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under an Attribution-ShareAlike 4.0 International (CC BY-SA 4.0) License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).